SPEC 599 ASHLESS SYNTHETIC CHAIN FLUID

THE NEW INNOVATIVE ADVANCE TECHNOLOGY SYNTHETIC CHAIN OIL FOR EXTREME HIGH TEMPERATURE PROTECTION

FEATURES:

SPEC’99 -599 is specially formulated for the high temperature lubrication of conveyer chains, and provide

· For Controlled Volatility & Reduced Consumption
· Long Life Lubrication up to 310°C
· Extreme Pressure & Anti Wear Protection
· Anti Oxidation, minimum residue build up
· Low Evaporation Rate At High Temperature Operation
· Rust & Corrosion Protection
· Ashless base oil

PRODUCT INFORMATION

CONTROLLED VOLATILITY: SPEC’99 599 tailored volatility insures time for base oil to penetrate links , pins, bushings, and minimize oil consumption.

GOOD WETTING PROPERTIES: SPEC’99 599 wetting aids migration of product to contacting surfaces for long life lubrication

SELF CLEANING PROPERTIES: SPEC’99 599 it’s nature of synthetic base oil combine with nature of detergency of the oil and its affinity to metal surfaces, to keep oven chains clean and lubricated properly , when subjected to heat.

RUST PROTECTION: SPEC’99 599 protect pin, bushings and other parts of the chain from corrosion , especially when expose to water and/or steam condensate.

EXTREME PRESSURE PROTECTION: SPEC’99 599 contain exceptional anti wear additive to provide extreme-pressure and anti wear protection which permit chain operation with a relatively lower power consumption. It prevent metal parts from seizing and odes not affect operational clearances.

ASHLESS : SPEC 599 used our proprietor refining base oil, which has ashless characteristic, that under extreme heat does not carbonized at all.

TYPICAL APPLICATION:
Lubrication of Oven Chains, Furnace parts such as pulleys, sprockets, hinges, bearings and other parts exposed to high temperature. Operation of drying ovens, curing ovens , designed for use in Glass Fiber Insulation Manufacturing, high temperature kilns (e.g brickyards ) , basic metal mills, heat treating plants, foundries.

APPLICATION RECOMMENDATIONS:
To obtain maximum effectiveness , SPEC’99 599 is highly recommended to apply on a new clean chains and slide rails. Because the build up carbon on the chain acts like a sponge to the synthetic chain oil and results in increased usage of oil. If the SPEC’99 599 was applied with petroleum base oil is a soft goo that will clog the pins on the pins and bush, as well as oil inlets of force feed lubricators.

TYPICAL SPECIFICATIONS

SAE Grade……………………………………. 50
Density g/cm @ 15°C………………………… 0.958
Gravity, API………………………………….. 16.2
Flash Point, COC °C (°F)…………………….. 250 ( 456)
Pour Point, °C (°F)…………………………… -40 (-40)
Viscosity :
SUS @ 100 °F…………………... 498
SUS @ 210 °F…………………... 60.6
CST @ 40 °C……………………. 95
CST @ 100 °C…………………... 10.1
Viscosity Index……………………………….. 156